Steel Bending | Barbados Vocational Training Board

Masonry - Beginners

Participants will be taught the basics of Masonry – introduction to batching and mixing materials, basic calculations, block laying and plastering, and techniques of plan reading.


Latest Course Information

  • May 31, 2025

    Duration:
    12 Weeks
    Day(s):
    Saturday
    Time:
    9:00 am -12:00 pm
    Tutor:
    Mr. Fontenelle
    Course Fee:
    $450.00

Frequently Asked Questions

Below are a few FAQs pertaining to this programme or course:

  • When do Evening Programme classes begin?

    Evening Programmes are run three times a year and begin approximately in January, May, and September. 

  • Is there an age limit?

    Yes, applicants must be at least age sixteen (16) to be considered for selection to most programmes. Some programmes require the student to be at least eighteen (18) years of age.

  • What is the Admissions Policy for Skills Training programmes?

    Applicants must be at least sixteen (16) years and should have completed nine (9) years of formal education to be accepted on the BVTB Skills Training Programme, except for the Bar and Restaurant Services and vehicle operations courses. Applicants must be eighteen (18) years or older to be eligible to apply for these courses. This stipulation is in accordance with Section 57 of the Liquor Licence Act of Barbados for the Bar and Restaurant Services course. The Skills Training Programme is free to all Barbadian nationals. Non-nationals are required to pay a course fee.

View all Questions

Training Centres

This course is held at the following training centre(s):

  • St. Lukes Skills Training Centre

    This centre is located at the old St. Luke’s Girl’s school and offers classes in Carpentry, Plumbing, Auto Electronics and other disciplines.

View all Centres

Testimonials

  • Patrick Evans

    The Skills Training experience for me was a very delightful one even though it had its challenges. Although I knew a little about mechanics the course Automotive Vehicle Engineering assisted me to understand on a broader scale what mechanics is really about, both the practical and the theory.

    At the end of the course I was given the opportunity to begin a job attachment at Nassco Ltd where I have been employed for the last three and a half years.

    Patrick Evans

    Apprentice at Nassco Ltd.

View all Testimonials